Click Next and now you will see the hardware setup interface. Select the following key because you need these settings to run code on c Nucleo.Ĥ. In the menu bar, click File, then click New, and select c project. I mark an important position with the buttons and blue:ģ. You may be asked to upgrade to pro, but you can continue to use the lite version after 5 seconds. Now open Atollic TrueSTUDIO for ARM 6.0.0. You can enter the device manager and to enter the Device Manager by clicking the Start button in the search bar. But if you want to check whether the driver is installed properly, you need to go to Device Manager to check STLINK virtual serial port. If you do not see any LED flashes, check the Power LED is green. Therefore, when you use the micro USB cable NUCLEO when connected to PC, it will begin to execute the code, and will automatically install the USB driver. When the first start Nucleo, NUCLEO run demo code, LED flashes at different speeds, and vary according to the number of times a user switches from LED speed. STM32F746xx Data Production data (3.2MB)ġ. ![]() Link above document, you may need to refer to the following documentation to help you write better code.Ģ. TrueStudio official Download: TrueStudio 6.0(860MB) But if you want to use the advanced features of ST-LINK debug, you need to buy the professional version. For programming / debugging it, lite version of it. You need to download TrueStudio 6.0 Lite. Yes, it is an advantage of ICD, you can see already written in the internal register data.įor more information about Nucleo development board, please see the following links: Nucleo - 144 F746ZG Development board user manualĬhinese version of the document : Nucleo - 144 F746ZG Development Board User Manual We will use ICD debugging capabilities of the code programming, and testing our internal registers to check the data written. We will be using traditional C programming language to develop board and use the IO port open / close LED. Use Micro USB cable connection, we can program the microcontroller using PC software. ICD can be used with a program other STM32F family of microcontrollers. ICD part of the development board has its own USB interface. The board includes an on-board online debugger (ICD), called ST-LINK V2-1, for programming the microcontroller. Nucleo - F746ZG development board STMicroelectronics STM32F746ZG based microcontroller core ARM Cortex M7. STM32F746 Nucleo - 144 F746ZG development board USB OTG or device full speed with Micro-AB connector (depending on STM32 support).External power sources: 3.3 V and 7 - 12 V on ST Zio or ST morpho connectors, 5 V on ST morpho connector.Three different interfaces supported on USB: virtual com port, mass storage, debug port Selection-mode switch to use the kit as a standalone ST-LINK/V2-1.On-board ST-LINK/V2-1 debugger/programmer with SWD connector:. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |